Changing Network Settings - Blackmagicdesign ATEM Live Installation And Operation Manual

The connection process is fast because all the network settings for each ATEM unit have a
different default IP address when shipped from the factory. This means when you connect them
all to each other, their network settings are automatically configured and will work straight away.
However, if you are adding a camera control panel to an already existing system, or you need
to manually assign a different IP address to avoid potential conflicts on your network, you can
enable DHCP so your panel determines the best IP address, or disable DHCP and set the IP
address manually.

Changing Network Settings

Changing network settings means manually setting the panel's IP address so it can join your
network, then entering the switcher's IP address on your panel so the switcher can be identified
by your panel. These settings are located in your camera control panel's 'settings' LCD menu.
The home screen is the first menu item you will see on the CCU's LCD. To access the network
settings, press the 'settings' soft button.
Press the 'settings' soft button on the LCD home screen
to access all the camera control panel's settings
The DHCP setting is the first setting in the sequence of menu pages. Under this setting is a row
of small dot icons. As you press the arrow soft button to navigate through the pages of settings,
the dot icons will illuminate to show which page you are on. All your camera control panel
settings are available via these pages.
To set the camera control panel's IP address:
1 If you want the panel to automatically set a compatible IP address, select the DHCP
setting by pressing the 'on' soft button.
TIP If you know your network's IP address, you can navigate to the next
setting page and check the panel's IP address setting to confirm it has
selected an address compatible with your network.
2 If you want to set the IP address manually, make sure the DHCP setting is set to 'off',
then press the arrow soft button to navigate to the 'panel IP address' setting.
3 Rotate the corresponding knobs to change the IP address fields.
Using ATEM Camera Control Panel 169