Blackmagicdesign ATEM Live Installation And Operation Manual page 12

If everything is working fine, you should see the lights on the Ethernet port start to flicker, and
the advanced panel should come alive with buttons illuminated. The LCD will show the source
names for sources switched to the program and preview outputs, plus other settings.
If you don't see this appear, then check that the switcher and the hardware panel are powered
correctly and/or power connectors are firmly plugged in.
If things are still not working, then you should make sure that your ATEM hardware panel is
connected directly to your switcher and not via a network. If this is correct, then the most likely
cause of the problem is the hardware panel and the switcher have IP addresses in different
ranges. In this case, you will need to check and set these as described later in this manual.
If you need to manually set the network settings, then you might need to get the assistance of a
technically minded friend who understands how to set IP addresses. By default, the switcher is
set to a fixed IP address of 192.168.10.240, and the ATEM advanced panels are set to a fixed IP
of 192.168.10.60. Go to the 'Connecting to a Network' section in this manual to see how to
check and set your switcher to these addresses. Then it should work OK with a direct
connection between the hardware panel and the switcher.
ATEM 1 M/E Advanced Panel rear connectors
ATEM 2 M/E Advanced Panel rear connectors
ATEM 4 M/E Advanced Panel rear connectors
Installing Blackmagic ATEM Software on Mac
Before installing any software you will need administrator privileges. It is also a good idea to
uninstall any previous versions of ATEM software present on your computer.
1 Ensure you have the very latest driver. Visit
2 Open the "Blackmagic ATEM Switchers" folder from the disc or downloaded disk image
and launch the "Blackmagic ATEM Switchers Installer Software".
3 Click Continue, Agree and Install buttons and the software will be installed on
your system.
www.blackmagicdesign.com/support
Getting Started 12