Blackmagicdesign ATEM Live Installation And Operation Manual page 26

Changing the Hardware Panel Network Settings
Because the hardware panel is also on the network and communicating with the switcher,
it also has network settings so it can connect to the network. These settings are different to
the switcher IP address, which is just where the panel is looking to find the switcher. The panel
network settings can be changed by following the steps below:
Changing Network Settings on ATEM Advanced Panel
Change network settings using the system control buttons and LCD soft controls
1 Press the 'home' button in the system control buttons to open the LCD home menu.
2 In the home menu, press the 'network' soft button to open the network settings.
3 The next step is to decide if you want the panel to use a fixed IP address or to be
automatically assigned an IP address from a DHCP server. Set DHCP on or off by
pressing the corresponding DHCP ON/OFF soft button.
NOTE If you're connecting direct to a switcher without a network, then you
won't have a DHCP server to assign an IP address automatically, so you will
want to select 'DHCP off'. ATEM Advanced Panels are delivered with a fixed IP
address set to 192.168.10.60 for a direct connection.
However, if your network has lots of computers that automatically assign IP
addresses via DHCP, then you can also select 'DHCP on' so the panel can get
its network information automatically. This is possible on the panel, and it's
only the switcher itself that always requires a fixed IP, as the switcher needs to
be found by the control panels at a known fixed address on your network.
If you select 'DHCP on', your network settings will be complete because the
panel network settings will be obtained from the network automatically.
Getting Started 26