Using Atem Camera Control Panel; Powering The Panel - Blackmagicdesign ATEM Live Installation And Operation Manual

Using ATEM Camera Control Panel

Traditionally, camera control units, or CCUs, have been designed for mounting inside a desk
with independent units for each camera. ATEM Camera Control Panel is a portable solution that
can be placed on a desk or solid surface with 4 CCUs built in so you can control up four
Blackmagic Design cameras at once. However, you aren't locked into controlling one single
camera for each CCU because you can select which camera you want to control.
This means you can control any number of Blackmagic Design cameras using the four CCUs on
one single panel, or if you have more than four cameras, you can use additional panels if you
want to assign each camera with a dedicated CCU. It's completely up to you.
NOTE Blackmagic Design cameras that can be controlled using ATEM Camera Control
Panel include URSA Broadcast, URSA Mini Pro 4.6K, URSA Mini, Blackmagic Studio
Camera and Blackmagic Micro Studio Camera.

Powering the Panel

To power your camera control panel, connect power via the IEC power input on the rear panel
using a standard IEC power cable. You can also use the 12V DC input if you want to connect
external power or redundancy via an external power supply, for example a UPS uninterrupted
power supply or external 12V battery.
Connect power via the power input on the rear panel
Using ATEM Camera Control Panel 167