Blackmagicdesign ATEM Live Installation And Operation Manual page 25

Setting the Switcher IP Location
To set the network location of the switcher on the hardware panel, so the panel can find the
switcher and communicate, follow these steps:
Changing the IP location on an ATEM advanced panel
1 When there is no communication with the switcher, the LCD will say 'connecting'
and notify you of the IP address it is searching for. If the panel can't find the switcher,
the connection will time out and a notification will ask you to check the IP address.
Press the 'network' soft button above the LCD to open the network settings.
2 In the network settings, press the right arrow in the system control buttons next to the
LCD to move to the 'switcher IP address' setting.
3 Now use the corresponding LCD soft control knobs to set the correct IP address for
your switcher.
4 Press the 'save changes' soft button to confirm the setting.
Your panel will now connect with your switcher.
On the ATEM Advanced Panel, press the 'network' LCD soft
button to open the network settings on the LCD, then use the
system control arrow buttons to navigate to the switcher IP
address setting. Use the soft controls to set the network IP
address for your switcher, and don't forget to save the changes.
NOTE Changing the switcher IP address on your panel does not change the
IP address of the switcher itself. It just changes where the control panel is looking to
find the switcher. If the control panel cannot find the switcher, then you might need to
check the switcher to see if it's been set correctly. To change the IP address of the
switcher, connect the switcher via USB to a computer and run Blackmagic ATEM Setup
as described previously in this manual.
Getting Started 25