Accessing The Dali Multi-Master Module; Module Configuration Notes; Construction Site Function" For Initial Startup - WAGO 750 Series Manual

WAGO-I/O-SYSTEM 750
753-647 DALI Multi-Master
Additional information
More information on commissioning is available on the WAGO website at:
www.wago.com
7.2

Accessing the DALI Multi-Master Module

You can access the DALI Multi-Master Module (753-647) from the WAGO DALI
Configurator.
A communication link must be set up via the IP address of the respective WAGO
PLC connected at the fieldbus node to ensure proper data exchange with the
DALI Multi-Master Module via the WAGO DALI Configurator. To set up the link,
click the [Settings] button on the ribbon of the WAGO DALI Configurator directly.
7.3

Module Configuration Notes

In the WAGO DALI Configurator view for module configuration, you can perform
general settings for the DALI Multi-Master Module. You can access this
configuration area in the MODULE SETTINGS tab. In this tab, you can define
specific settings for:
• Easy mode
• Full mode
You can also define general settings:
• Network polling after power ON
• Cyclic control gear polling
• Behavior in the event of faulty telegrams
In addition, the internal DALI network power supply can be disabled in the DALI
Multi-Master Module in the MODULE SETTINGS tab to connect an external DALI
network power supple ("Enable Internal Power Supply" checkbox).
You can press the [Read] button on the ribbon to read the settings of the DALI
Multi-Master Module. You can press the [Write] button to write the settings made
to the DALI Multi-Master Module.
7.4

"Construction Site Function" for Initial Startup

A helpful function when configuration a module for initial startup is the so-called
"Construction Site Function". To use this function, the DALI line must be supplied
via the DALI Multi-Master Module.
Proceed as follows:
1. Select the "Central OFF" function in the WAGO DALI Configurator in the
MODULE SETTINGS tab ("Behavior after Short Circuit" selection box).
Commissioning 59
Manual
Version 1.4.3