Inserting And Removing Devices; Inserting The I/O Module; Figure 7: Insert I/O Module (Example); Figure 8: Snap The I/O Module Into Place (Example) - WAGO 750 Series Manual

Hide thumbs Also See for 750 Series:
Table of Contents

Advertisement

42
Mounting
5.2

Inserting and Removing Devices

Do not work when devices are energized!
High voltage can cause electric shock or burns.
Switch off all power to the device prior to performing any installation, repair or
maintenance work.
5.2.1

Inserting the I/O Module

1.
Position the I/O module so that the tongue and groove joints to the fieldbus
coupler or controller or to the previous or possibly subsequent I/O module
are
engaged.

Figure 7: Insert I/O Module (Example)

2.
Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.

Figure 8: Snap the I/O Module into Place (Example)

With the I/O module snapped in place, the electrical connections for the data
contacts and power jumper contacts (if any) to the fieldbus coupler or controller
or to the previous or possibly subsequent I/O module are established.
Manual
Version 1.4.3
WAGO-I/O-SYSTEM 750
753-647 DALI Multi-Master

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dali multi-master 753-647

Table of Contents