Removing The I/O Module; I/O Modules With Pluggable Wiring Level (Series 753); Figure 9: Removing The I/O Module (Example); Figure 10: Plug And I/O Module - WAGO 750 Series Manual

WAGO-I/O-SYSTEM 750
753-647 DALI Multi-Master
5.2.2

Removing the I/O Module

Note
Remove pluggable wiring!
Before removing a 753 Series I/O Module from the node, you must first
remove the plug (pluggable wiring) from the I/O module (see section "Plug
Removal")!
1. Remove the I/O module from the node by pulling the tab.

Figure 9: Removing the I/O Module (Example)

Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
5.3 I/O Modules with Pluggable Wiring Level (Series
753)
For wiring, a plug is plugged into the bottom of the module of all 753 Series I/O
modules. The plug can be completely removed together with the wiring,
simplifying replacement of defective modules from the assembly.

Figure 10: Plug and I/O Module

Miniature WSB marking tags ensure that the right plug is matched up with the
right I/O module (see figure below).
Mounting 43
Manual
Version 1.4.3