Installing And Connecting The Sensor - Banner iVu BCR Gen2 Series Quick Start Manual

Installing and Connecting the Sensor

The iVu BCR sensor requires a bracket for mounting. Three brackets are available from Banner. The brackets allow the
sensor to be mounted either perpendicular to the part or at an adjustable angle.
Thread three M4 x 4mm screws through the bracket into the mounting holes in the bottom of the sensor. Tighten all three
screws.
Table 1: iVu Brackets
SMBIVURAL
Cable Connections for iVu BCR with Integrated Display
The cable connections on the iVu BCR sensor are shown below, and the power I/O connections (B) are defined in
on page 2.
Table 2: Power I/O Connections
Pin # Wire Color
1 White
2 Brown
3 Green
4 Yellow
5 Gray
6 Pink
7 Blue
8 Red
9 Orange
10 Light Blue
11 Black
12 Violet
Cable Connections for the iVu BCR with a Remote Display
The cable connections on the iVu BCR sensor are shown below, and power I/O connections (B) are defined in
page 3.
2
SMBIVURAR
A USB Connector
B Power I/O Connector
NOTE: Micro video lens model shown. C-Mount model
connections are identical.
Description
Output 1
10-30V dc
Output 2
Strobe Out (5V dc only)
Remote Teach
External Trigger
Common (Signal Ground)
Ready
Not used
RS-232 TX
RS-232 Signal Ground
RS-232 Rx
www.bannerengineering.com - Tel: +1-763-544-3164
iVu BCR Gen2 Series Sensor
SMBIVUU
Table 2
Direction
Output
Input
Output
Output
Input
Input
Input
Output
N/A
Output
Output
Input
Table 3
P/N 178445 Rev. A
on