Controller Coherentdsp - Cisco NCS 1004 Command Reference Manual

Commands

controller coherentDSP

To configure the coherent DSP controller, use the controller coherentDSP command in the Coherent DSP
controller configuration mode.
controller coherentDSP
|15-min | 24-hour } { fec | otn } { report | threshold } value ] | [ perf-mon { enable | disable
} ] | [ loopback internal ] | [ secondary-admin-state { maintenance | normal }] | [
shutdown ] | [ tti { sent | expected } { ascii | hex }
Syntax Description
R/S/I/P
description description
fec fec-value
pm {30-sec |15-min | 24-hour}
{fec | otn} {report |
threshold} value
perf-mon { enable | disable
}
loopback internal
secondary-admin-state
shutdown
tti sent {ascii | hex} tti-string
tti expected {ascii | hex}
tti-string
gcc0
R/S/I/P [ description ]
Rack/Slot/Instance/Port of the coherent DSP controller.
Description of the coherent DSP controller.
Configures the FEC on the controller. The supported options on the 1.2T
line card are StandardSD15 and StandardSD27.
Configures performance monitoring parameters for 30 second,15 minute,
or 24 hour intervals.
The fec keyword configures FEC PM data in 30 second, 15 minute, or 24
hour intervals.
The otn keyword configures OTN PM data in 30 second, 15 minute, or
24 hour intervals.
The report keyword configures TCA reporting status.
The threshold keyword configures threshold values on PM parameters.
Enables or disables performance monitoring.
Configures the internal loopback mode on the controller.
For the 1.2T line card, internal and line loopbacks are supported on the
Ethernet controllers whereas only internal loopback is supported on the
CoherentDSP controllers.
Configures the administrative state of the controller. The values are
maintenance or normal.
Disables the configuration of the controller.
Configures the Trail Trace Identifier (TTI) ASCII or hex string to be sent.
SAPI, DAPI, and operator inputs are not supported.
Configures the expected TTI ASCII or hex string. The OTUK-TIM alarm
is raised if the received TTI string does not match the expected TTI string.
SAPI, DAPI, and operator inputs are not supported.
Enables the GCC0 interface.
controller coherentDSP
| [ fec fec-value ] | [ pm { 30-sec
tti-string ][ gcc0
Command Reference for Cisco NCS 1004
9