Cisco NCS 1004 Command Reference Manual page 16

controller coherentDSP
None
Command Default
Coherent DSP controller configuration
Command Modes
Command History
Release
Release
7.0.1
Release
7.1.1
Example
The following is a sample in which performance monitoring parameters of Coherent DSP controller
is configured in 30 second intervals.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller coherentDSP 0/0/1/1 pm 30-sec fec threshold post-fec-ber
max OE-15
RP/0/RP0/CPU0:ios(config)#commit
The following example shows how to configure TTI on a coherentDSP controller with the sent and
expected strings set to the same ASCII string. The state of the controller is up.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller coherentDSP 0/1/0/1 tti sent ascii 1234
RP/0/RP0/CPU0:ios(config)#controller coherentDSP 0/1/0/1 tti expected ascii 1234
RP/0/RP0/CPU0:ios(config)#commit
The following example shows how to configure TTI on a coherentDSP controller with the sent and
expected strings set to different ASCII strings. The state of the controller goes down and the
OTUK-TIM alarm is raised.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller coherentDSP 0/1/0/1 tti sent ascii 1234
RP/0/RP0/CPU0:ios(config)#controller coherentDSP 0/1/0/1 tti expected ascii 5678
RP/0/RP0/CPU0:ios(config)#commit
The following is a sample to enable the GCC0 interface.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller CoherentDSP0/0/0/0
RP/0/RP0/CPU0:ios(config-CoDSP)#gcc0
RP/0/RP0/CPU0:ios(config-CoDSP)#commit
RP/0/RP0/CPU0:ios(config-CoDSP)#exit
Command Reference for Cisco NCS 1004
10
Modification
This command was introduced.
gcc0 keyword was added.
Commands