Interface Gcc0 - Cisco NCS 1004 Command Reference Manual

Commands

interface gcc0

To configure the GCC0 interface, use the interface gcc0 command in configuration mode.
interface gcc0
Syntax Description
R/S/I/P
None
Command Default
Configuration
Command Modes
Command History
Release
Release
7.1.1
Example
The following is a sample to configure the GCC0 interface using the static IP address.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#interface gcc0 0/1/0/0
P/0/RP0/CPU0:ios(config-if)#ipv4 address 10.1.1.1 255.255.255.0
RP/0/RP0/CPU0:ios(config-if)#commit
RP/0/RP0/CPU0:ios(config-if)#exit
RP/0/RP0/CPU0:ios(config)#exit
RP/0/RP0/CPU0:ios#show run interface gcc0 0/1/0/0
interface GCC00/1/0/0
ipv4 address 10.1.1.1 255.255.255.0
!
The following is a sample to configure the GCC0 interface using the loopback IP address.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:R2(config)#interface gcc0 0/1/0/0
RP/0/RP0/CPU0:R2(config-if)#ipv4 unnumbered loopback 0
RP/0/RP0/CPU0:ios(config-if)#exit
RP/0/RP0/CPU0:ios(config)#exit
R/S/I/P
Rack/Slot/Instance/Port of the GCC0 interface.
Modification
This command is
introduced.
Command Reference for Cisco NCS 1004
interface gcc0
37