Cisco NCS 1004 Command Reference Manual page 79

Commands
Fri Feb 22 20:01:00.521 UTC
Operational data for interface HundredGigECtrlr0/1/0/10:
State:
Administrative state: enabled
Operational state: Up
LED state: Green On
Maintenance: Enabled
AINS Soak: Pending
Laser Squelch: Enabled
Phy:
Media type: Not known
Statistics:
Autonegotiation disabled.
Operational values:
Speed: 100Gbps
Duplex: Full Duplex
Flowcontrol: None
Loopback: Line
BER monitoring:
Forward error correction: Standard (Reed-Solomon)
Holdoff Time: 0ms
The following example displays the optics controller statistics with AINS Soak in running state.
RP/0/RP0/CPU0:ios#show controller optics 0/1/0/3
Thu Feb 21 19:45:41.088 UTC
Controller State: Up
Transport Admin State: Automatic In Service
Laser State: On
LED State: Green
Optics Status
Total Duration: 0 hour(s) 30 minute(s)
Remaining Duration: 0 hour(s) 30 minute(s) 0 second(s)
FEC:
Corrected Codeword Count: 0
Uncorrected Codeword Count: 6
Not supported
Optics Type: Grey optics
Alarm Status:
-------------
Detected Alarms: None
LOS/LOL/Fault Status:
Alarm Statistics:
-------------
HIGH-RX-PWR = 0
HIGH-TX-PWR = 0
HIGH-LBC = 0
LOW-RX-PWR = 0
LOW-TX-PWR = 0
HIGH-DGD = 0
Command Reference for Cisco NCS 1004
show controllers
73