Controller Optics - Cisco NCS 1004 Command Reference Manual

Commands

controller optics

To configure the optics controller, use the controller optics command in the optics controller configuration
mode.
controller optics R/S/I/P [ baud-rate rate] [ bits-per-symbol value] [ cd-max cd-max | cd-min
cd-min | cd-low-threshold cd-low | cd-high-threshold cd-high | dgd-high-threshold dgd-value
| lbc-high-threshold lbc-value | osnr-low-threshold osnr-value description description |
rx-high-threshold rx-high | rx-low-threshold rx-low | tx-high-threshold tx-high | tx-low-threshold
tx-low | sec-admin-state {maintenance | normal}
| transmit-shutdown | perf-mon { enable | disable } | pm [ 30-sec |15-min | 24-hour ]
optics [ report | threshold {cd | dgd | lbc | lbc-pc | opr | opt | osnr | pcr | pdl
| pn | sopmd | rx-sig-pow | rx-sig-pow-dbm }]
To configure the sub-sea parameters for the optics controller, use the following command:
controller optics R/S/I/P [ filter-roll-off-factor value | filter-roll-off-factor value | rx-voa
target-power value | rx-voa fixed-ratio value | enh-colorless-mode value | enh-sop-tol-mode
value | nleq-comp-mode value | cross-pol-gain-mode value | cross-pol-weight-mode value |
cpr-win-mode value | cpr-ext-win-mode value | submarine-params type value ]
For more information about the sub-sea parameters, see the Configuration Guide for Cisco NCS 1004, IOS
XR Release 7.0.1.
Syntax Description
R/S/I/P
baud-rate rate
bits-per-symbol value
cd-max cd-max
cd-min cd-min
cd-low-threshold cd-low
cd-high-threshold cd-high
| shutdown | transmit-power transmit-power
Rack/Slot/Instance/Port of the optics controller.
Sets baud-rate for this controller in GBd.
Sets bits-per-symbol for this controller.
(Only for trunk optics controllers) Maximum chromatic dispersion.
The range is -350000 to +350000 ps/nm.
(Only for trunk optics controllers) Minimum chromatic dispersion.
The range is -350000 to +350000 ps/nm.
(Only for trunk optics controllers) Minimum acceptable chromatic
dispersion. The CD alarm is raised if the chromatic dispersion goes
below this value.
The range is -350000 to +350000 ps/nm.
(Only for trunk optics controllers) Maximum acceptable chromatic
dispersion. The CD alarm is raised if the chromatic dispersion exceeds
this value.
The range is -350000 to +350000 ps/nm.
Command Reference for Cisco NCS 1004
controller optics
15