Match Identity Remote Address - Cisco NCS 1004 Command Reference Manual

match identity remote address

match identity remote address
To specify the IP address of the remote node, use the match identity remote address command in IKEv2
profile configuration mode.
match identity remote address { ipv4-address [ subnet-mask]}
Syntax Description
ipv4-address
subnet-mask
None
Command Default
IKEv2 profile configuration
Command Modes
Command History
Release
Release
7.0.1
Example
The following is a sample in which an IKEv2 profile is configured.
RP/0/RP0/CPU0:ios#configure
Thu Mar
RP/0/RP0/CPU0:ios(config)#ikev2 profile profile1
RP/0/RP0/CPU0:ios(config-ikev2-profile-profile1)#match identity remote address 10.0.0.1
255.255.255.0
RP/0/RP0/CPU0:ios(config-ikev2-profile-profile1)#keyring kyr1
RP/0/RP0/CPU0:ios(config-ikev2-profile-profile1)#lifetime 120
RP/0/RP0/CPU0:ios(config-ikev2-profile-profile1)#commit
Thu Mar
RP/0/RP0/CPU0:ios(config-ikev2-profile-profile1)#exit
RP/0/RP0/CPU0:ios(config)#exit
RP/0/RP0/CPU0:ios#show ikev2 profile profile1
Thu Mar
Profile Name
===============================================================================
Keyring
Lifetime(Sec)
DPD Interval(Sec)
DPD Retry Interval(Sec)
Match ANY
Total Match remote peers
Addr/Prefix
Command Reference for Cisco NCS 1004
50
IP address of the remote
node.
Subnet mask address.
Modification
This command is
introduced.
7 20:00:36.490 UTC
7 20:15:03.401 UTC
7 20:15:25.776 UTC
: profile1
: kyr1
: 120
: 10
: 2
: NO
: 1
: 10.0.0.1/255.255.255.0
Commands