Cisco NCS 1004 Command Reference Manual page 37

Commands
No slice is configured.
Command Default
You must configure the card mode before enabling LLDP drop.
Cisco IOS XR Configuration
Command Modes
Command History
Release
Release
7.0.1
Release
7.1.1
Release
7.2.1
Example
The following is a sample in which the card is configured in the muxponder mode with 100GE client
payload and 500G trunk payload.
RP/0/RP0/CPU0:ios#configure
Sun Feb 24 14:09:33.989 UTC
RP/0/RP0/CPU0:ios(config)#hw-module location 0/2 mxponder client-rate 100GE
RP/0/RP0/CPU0:ios(config)#hw-module location 0/2 mxponder trunk-rate 500G
RP/0/RP0/CPU0:ios(config)#commit
The following is a sample in which the card is configured in the muxponder mode with a 550G trunk
payload.
RP/0/RP0/CPU0:ios#config
Tue Oct 15 01:24:56.355 UTC
RP/0/RP0/CPU0:ios(config)#hw-module location 0/1 mxponder client-rate 100GE
RP/0/RP0/CPU0:ios(config)#hw-module location 0/1 mxponder trunk-rate 550G
RP/0/RP0/CPU0:ios(config)#commit
The following is a sample in which the card is configured in the muxponder mode with OTU4 client
payload and 500G trunk payload.
RP/0/RP0/CPU0:ios#configure
Sun Feb 24 14:09:33.989 UTC
RP/0/RP0/CPU0:ios(config)#hw-module location 0/2 mxponder client-rate OTU4
RP/0/RP0/CPU0:ios(config)#hw-module location 0/2 mxponder trunk-rate 500G
RP/0/RP0/CPU0:ios(config)#commit
The following is a sample in which the card is configured in the muxponder slice 0 mode with a
300G trunk payload.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#hw-module location 0/1 mxponder-slice 0 client-rate 100GE
RP/0/RP0/CPU0:ios(config)#hw-module location 0/1 mxponder-slice 0 trunk-rate 300G
RP/0/RP0/CPU0:ios(config)#commit
The following is a sample in which the card is configured in the muxponder slice 1 mode with a
400G trunk payload.
Modification
This command was introduced.
regen keyword was added.
arp-snoop keyword was added.
Command Reference for Cisco NCS 1004
hw-module
31