Neighbor - Cisco NCS 1004 Command Reference Manual

Commands

neighbor

To specify an LMP neighbor for GMPLS and enter commands to configure the neighbor, use the neighbor
command in the LMP GMPLS-UNI configuration mode.
neighbor name
Syntax Description
name
None
Command Default
LMP GMPLS-UNI configuration
Command Modes
Command History
Release
Release
7.0.1
Under the LMP GMPLS UNI submode, this command creates a submode in which other properties of the
Usage Guidelines
neighbor can be specified.
Example
The following example shows how to specify the neighbor UN01 for the GMPLS-UNI controller
0/0/0/0.
RP/0/RP0/CPU0:ios(config)#lmp
RP/0/RP0/CPU0:ios(config-lmp)#gmpls optical-uni
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni)#neighbor UN01
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni-nbr-UN01)#exit
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni)#controller Optics0/0/0/0
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni-cntl)#neighbor UN01
RP/0/RP0/CPU0:ios(config-lmp-gmpls-uni-cntl)#
Specifies the name of the LMP neighbor.
Modification
This command is
introduced.
Command Reference for Cisco NCS 1004
neighbor
53