Section 1: Configuration For Svp Operation; Network Topology; Configuring A New Controller Starting From Factory Defaults - Cisco 1230AG - Aironet - Wireless Access Point Configuration Manual

Section 1: Configuration for SVP Operation

Network Topology

Configuring a New Controller Starting from Factory Defaults

PN: 1725-36192-001_H
Cisco Wireless LAN Controllers with 1100, 1130, 1140, 1200, 1230, 1240, 1250 APs
SIP PBX
SVP Server
LINK ACT LINK ACT
STATUS PS1
ALARM PS2
SERVICE CONSOLE UTILITY 1
Cisco WLC
Cisco AP
SpectraLink 8000 series
Wireless Telephones
This configuration is not applicable to all customer environments.
1. Initial provisioning of the controller is done via the command line
interface (CLI). Connect a null modem serial cable between the
console port of the controller and the serial port of a PC.
2. Open a terminal program, such as Hyper Terminal, and configure the
port settings to 9600 baud, no parity, 8 data bits and 1 stop bit.
RADIUS Authentication Server
(for WPA2-Enterprise Security)
TFTP Server, DHCP Server
Cisco 4400 Series
WIRELESS LAN CONTROLLER
LINK
ACT
2 MODEL 4402 50 AP
Cisco AP
Wireless Data Client
7