Cisco NCS 1004 Command Reference Manual page 24

controller optics
Optics controller configuration
Command Modes
The configurations for chromatic dispersion (cd-max, cd-min, cd-low-threshold, and cd-high-threshold) must
Usage Guidelines
be performed only after the hw-module configuration. These configurations must be removed before the no
hw-module configuration.
Example
The following example shows how to configure the optics controller and set the high power threshold
at the transmit and receive side.
RP/0/RP0/CPU0:ios# configure
RP/0/RP0/CPU0:ios(config)#controller optics 0/0/1/1
RP/0/RP0/CPU0:ios(config-optics)#rx-high-threshold 200
RP/0/RP0/CPU0:ios(config-optics)#tx-high-threshold 300
The following example shows how to configure the optics controller and set the ranges for chromatic
dispersion.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller optics 0/0/1/1
RP/0/RP0/CPU0:ios(config-optics)#cd-max 10000
RP/0/RP0/CPU0:ios(config-optics)#cd-min 2000
The following is a sample in which the performance monitoring parameters of optics controller is
configured in 24 hour intervals.
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#controller optics 0/0/1/1 pm 24-hour optics threshold osnr max
345
RP/0/RP0/CPU0:ios(config)#commit
Command Reference for Cisco NCS 1004
18
Commands