Fault-Profile Apply - Cisco NCS 1004 Command Reference Manual

Commands

fault-profile apply

Use the fault-profile apply command in the global configuration mode, to apply a fault profile at the node
level or card level.
fault-profile name apply rack0 slot location
Syntax Description
fault-profile name
rack 0 slot location
No default behavior or values.
Command Default
Global Configuration
Command Modes
Command History
Release
Release
7.1.1
Example
The following example shows how to use the fault profile apply command.
RP/0/RP0/CPU0: router (config) # fault profile f1 apply rack 0 slot ALL
Name of the fault profile.
Sets the profile at the node level or line card level.
Modification
This command was introduced.
Command Reference for Cisco NCS 1004
fault-profile apply
27