Show Inventory - Cisco NCS 1004 Command Reference Manual

show inventory

show inventory
To retrieve and display the physical inventory information, use the show inventory command in XR EXEC
or administration EXEC mode.
XR EXEC Mode
show inventory [all | oid | raw | location location ]
Administration EXEC Mode
show inventory [all | chassis | fan | power | raw | location location ]
Syntax Description
all
fan
power
raw
chassis
location location
oid
All hardware inventory information is displayed.
Command Default
XR EXEC
Command Modes
Administration EXEC
Command History
Release
Release
7.0.1
Enter the show inventory command with the raw keyword to display every RFC 2737 entity installed in NCS
Usage Guidelines
1004, including those without a PID, unique device identifier (UDI), or other physical identification. The raw
keyword is primarily intended for troubleshooting problems with the show inventory command itself.
Example
The following examples show sample output from the show inventory command in both EXEC and
Administration EXEC modes.
sysadmin-vm:0_RP0# show inventory
Thu Mar
Command Reference for Cisco NCS 1004
90
(Optional) Displays inventory information for all the physical entities.
(Optional) Displays inventory information for the fans.
(Optional) Displays inventory information for the power supply.
(Optional) Displays raw information about the chassis for diagnostic purposes.
(Optional) Displays inventory information for the entire chassis.
(Optional) Displays inventory information for a specific node, or for all nodes in the
chassis.
(Optional) Displays inventory information along with oid.
Modification
This command was introduced.
7 12:49:15.974 UTC+00:00
Commands