Configuring The Interfaces; Configuring The T3 Controller - Cisco OSM-12CT3/T1 - Optical Services Module Multiplexor Configuration

Configuring the Interfaces

•
•
•
Configuring the Interfaces
This chapter includes these sections:
•
•
•
•
•
•

Configuring the T3 Controller

To configure the controller, perform this task:
Optical Services Modules Installation and Configuration Note, 12.2SR
7-6
Configure class-based marking as described in the Class-Based Marking Feature Module at this
URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121t/121t5/cbpmark2
.htm
Classification and priority marking based on the following:
– Ethertype
– IP Source Address (SA)
IP Destintation Address (DA)
–
TCP port number
–
UDP port number
–
IP SA + TCP/UDP port number + IP DA + TCP/UDP port number
–
Class-based weighted fair queuing (CBWFQ) on the WAN ports.
Low latency queuing (LLQ) on the WAN ports.
For general information on classification, marking, and queuing in IOS, refer to the "Classificiation"
chapter of the Cisco IOS Quality of Service Solutions Configuration Guide, Release 12.1 at this
URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/qos_c/index.htm
For information about platform-independent IOS QoS commands, refer to the Cisco IOS Quality of
Service Solutions Command Reference, Release 12.1at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/qos_r/index.htm
Configuring the T3 Controller, page 7-6
Configuring the Unchannelized DS3 Interface, page 7-7
Configuring the Channelized DS3 Interface, page 7-9
Configuring Distributed MLPPP, page 7-11
Configuring the T1/NxDS0 Lines, page 7-9
Configuring the E1 Lines, page 7-10
Chapter 7 Configuring the Channelized 12-port CT3/T1 Optical Services Modules
OL-9465-03