Signalling Refresh Out-Of-Band Missed - Cisco NCS 1004 Command Reference Manual

signalling refresh out-of-band missed

signalling refresh out-of-band missed
To specify the number of missed refresh messages allowed before states are deleted for optical tunnels, use
the signalling refresh out-of-band missed command in RSVP controller configuration mode.
signalling refresh out-of-band missed mis-count
Syntax Description
mis-count
The default value is 12.
Command Default
RSVP controller configuration
Command Modes
Command History
Release
Release
7.0.1
This command applies only to the RSVP sessions associated with GMPLS UNI tunnels.
Usage Guidelines
Example
The following example shows how to specify a maximum of 10 messages for the number of allowed
missed refresh messages.
RP/0/RP0/CPU0:ios(config)#rsvp
RP/0/RP0/CPU0:ios(config-rsvp)#controller Optics0/0/0/0
RP/0/RP0/CPU0:ios(config-rsvp-ctrl)#signalling refresh out-of-band missed 10
RP/0/RP0/CPU0:ios(config-rsvp-ctrl)#
Command Reference for Cisco NCS 1004
102
Number of missed refresh messages allowed before states are deleted for optical tunnels (1-48).
Modification
This command is
introduced.
Commands