Address - Cisco NCS 1004 Command Reference Manual

Commands

address

To configure the IP address of the peer node during keyring configuration, use the address command in
keyring configuration mode.
address { ipv4-address [ subnet-mask]}
Syntax Description
ipv4-address
subnet-mask
None
Command Default
Keyring configuration
Command Modes
Command History
Release
Release
7.0.1
Example
The following is a sample in which an OTNSec policy is configured.
RP/0/RP0/CPU0:ios#conf
Thu Mar
RP/0/RP0/CPU0:ios(config)#keyring kyr1
RP/0/RP0/CPU0:ios(config-keyring-kyr1)#peer peer1
RP/0/RP0/CPU0:ios(config-keyring-kyr1-peer-peer1)#address 10.0.0.1 255.255.255.0
RP/0/RP0/CPU0:ios(config-keyring-kyr1-peer-peer1)#pre-shared-key key1|clear
RP/0/RP0/CPU0:ios(config-keyring-kyr1-peer-peer1)#commit
Thu Mar
RP/0/RP0/CPU0:ios(config-keyring-kyr1-peer-peer1)#exit
RP/0/RP0/CPU0:ios(config-keyring-kyr1)#exit
RP/0/RP0/CPU0:ios(config)#exit
RP/0/RP0/CPU0:ios#show keyring kyr1
Thu Mar
Keyring Name
===============================================================================
Total Peers
-------------------------------------------------------------------------------
Peer Name
IP Address
Subnet Mask
Local PSK
Remote PSK
IP address of the peer
node.
Subnet mask address.
Modification
This command was
introduced.
7 19:33:14.594 UTC
7 19:54:33.314 UTC
7 19:58:07.135 UTC
: kyr1
: 1
: peer1
: 10.0.0.1
: 255.255.255.0
: Configured
: Configured
Command Reference for Cisco NCS 1004
address
7