Led Light Installation - Landoll 2132 Operator's Manual

LED Light Installation

NOTE
Refer to See Figure 3-22
harnesses placement.
1. Attach LH and RH light bracket assemblies, light
mount, light plates to center frame using 5/8 x 13 x
3-5/8 u-bolts, 5/8 lock nuts
2. Attach ag flasher control module to bottom of right
tail light mount with 1/4 x 1-1/2 bolts, 1/4 lock nuts.
3. Attach left and right side red ag lamp, reflector
mounts to frame assembly, mount bracket using 1/2 x
10 bolts, 1/2 flat washers, 1/2 lock nuts.
4. Attach the ag red single LED lamps to tail light
mounts using 1/4 x 1-1/2 bolts, 1/4 lock nuts.
32
for light bracket and wiring
See Figure 3-21 .
ASSEMBLY INSTRUCTIONS
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear
5. Install the rear warning light harness to the frame.
Connect the 3 pin ends to the red warning lights.
Connect 6 pin to the ag flasher control module. See
Figure See Figures 3-20
designations.
6. Attach two, 2 pin, 132" light harness extensions to
the 2 pin connector of the right side of rear light
harness, run harnesses through all hose loops going
to front of center frame, through the RH light bracket
assembly. Fasten 2 pin connector to amber ag lamp.
7. Attach one, 2 pin, 204" light harness extension to the
2 pin connector of the left side of rear light harness,
run harness through all hose loops going to front of
center frame, through the LH light bracket assembly.
Fasten 2 pin connector to amber ag lamp.
8. Attach the amber ag LED lamps to light bracket
assemblies using 1/4 x 1-1/2 bolts, 1/4 lock nuts.
9. Route main harness through all hose clamps/hose
loops from hitch to the rear of center frame, connect
the 4 pin end to the ag flasher control module.
10. Insure that the harnesses are clear of any moving
parts and secure the harnesses with tie wraps
provided.
11. Two 34" harnesses are provided if needed for main
harness to reach from flasher control module to the
tractor See Figures
12. Install the stor-away holder to hose holder on hitch
with 1/4-20 x 3/4 hex head cap screws and hex lock
nuts See Figures 3-3.
See Figures 3-22.
for LED harness wire
3-21.
3-31