Light Installation - Landoll Weatherproofer III 2310 Series Operator's Manual

ASSEMBLY INSTRUCTIONS

Light Installation

NOTE
See Figures 2-1 thru 2-8 for light bracket placement. If
no dimension is given for a bracket, it should be located
against frame member as shown in drawing.
1. Attach inner tail light mounting bracket supports to
the center frames using 1/2-13 x 8-1/2 hex head cap
screws, warning light bars, and hex lock nuts (See
Figure 3-22.)
2. Attach outer LH and RH light brackets to frame
weldment using 1/2-13 x 9-1/2 hex head cap screws,
warning light bars, and hex lock nuts.
3-28
3. Attach red brake lamps to inner tail light mounting
bracket supports and amber lamps to outer light
brackets using 1/4-20 x 1-1/4 hex head cap screws
and hex lock nuts.
4. Connect warning light harnesses to lights. Note that
2-34" harness extensions are required at the rear of
the main harness for adequate length.
5. Attach SMV emblem and mounting bracket to rear
center frame bar using 1/2-13 x 5-1/2 hex head cap
screws, 1/4-20 x 3/4 hex head cap screws, and hex
lock nuts. The SMV sign should be centered on the
rear bar of the frame.
F-556-0910 Edition