Light Installation - Landoll 2130 Operator's Manual

3-11 LIGHT INSTALLATION

Note: See Figures 2-1 - 2-14 for light bracket
placement. If no dimension is given for a
bracket, it should be located against frame
member as shown in drawing.
3-11.1 Attach inner tail light mounting bracket
supports to the center frames using 1/2-13 x
8-1/2 hex head cap screws, warning light
bars, and hex lock nuts (See Figure 3-16).
3-11.2 Connect enhanced lighting module to
the right inner tail light bracket using #8-32 x
1/2 slotted pan head screws and hex nut.
3-11.3 Attach outer lh and rh light brackets to
frame weldment using 1/2-13 x 5-1/2 hex
head cap screws, warning light bars, and hex
lock nuts.
IMPORTANT
OUTER LIGHT BRACKETS NEED TO BE SLID
REARWARD AS FAR AS POSSIBLE. SEE FIG-
URES 2-1 - 2-14 FOR LIGHT BRACKET
PLACEMENT.
3-11.4 Attach red brake lamps to inner tail light
mounting bracket supports and amber lamps
to outer light brackets using 1/4-20 x 1-1/4
hex head cap screws and hex lock nuts.
3-11.5 Connect warning light harnesses to
lights.
3-11.6 Attach SMV emblem and mounting
bracket to rear center frame bar using warn-
ing light bar, 1/2-13 x 5-1/2 hex head cap
screws, 1/4-20 x 3/4 hex head cap screws,
and hex lock nuts. The SMV sign should be
centered on the rear bar of the frame.
3-11.7 Attach red, orange, and yellow reflec-
tors to outer rh and lh tail light mounting
brackets.
3-25