Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
LED Light Installation
1. Attach LH and RH light bracket assemblies to center
frame using 5/8-11 x 6-11/16 x 5-1/2 u-bolt and 5/8
lock nuts
See Figures
2. Attach ag flasher control module to bottom of right
tail light mount with 1/4-20 x 1-1/2 cap screws and
lock nuts.
3. Attach right tail light mount and ag flasher control
module to frame assembly with 5/8-11 x 4 x 6-1/2
u-bolts and 5/8-11 flange lock nuts.
4. Attach the ag red single LED lamps to tail light
mounts using 1/4-20 x 1-1/2 hex head cap screws
and lock nuts.
5.
See Figures 2-22
in Chapter 2 for light bracket
placements.
32tT
3-36
3-25.
6. Install the rear warning light harness to the frame.
Connect 2 pin and 3 pin ends to each of the warning
lights. Connect 6 pin to the ag flasher control module.
See Figures 3-24
for harness wire designations.
7. Attach front warning harness to frame. Connect 4 pin
end to the ag flasher control module.
8. Insure that the harnesses are clear of any moving
parts and secure the harnesses with tie wraps
provided.
9. Install the stor-away holder to hose holder on hitch
with 1/4-20 x 1 hex screws and lock nuts
"Frame and Hitch Assembly" on page 3-2.)
10. Install smv mount and smv mount bar to rear tube of
LH center frame with 1/2-13 hex screws and 1/2 lock
nuts. Attach smv emblem to smv mount with1/4-20 x
1 hex screws, and 1/4 lock nuts
11.
See Figures 2-22
in Chapter 2 for smv placement,
wiring harness routing and connector locations.
(See
F-1072-0320
Advertisement
Table of Contents
