Light Installation - Landoll 2110 Operator's Manual

3-11 LIGHT INSTALLATION

Note: See Figures 2-1 - 2-10 for light bracket
placement. If no dimension is given for a
bracket, it should be located against frame
member as shown in drawing.
3-11.1 Attach inner tail light mounting bracket
supports to the center frames using 1/2-13 x
8-1/2 hex head cap screws, warning light
bars, and hex lock nuts (See Figure 3-11).
3-11.2 Attach outer lh and rh light brackets to
frame weldment using 1/2-13 x 7-1/2 hex
head cap screws, warning light bars, and hex
lock nuts.
3-11.3 Attach red brake lamps to inner tail light
mounting bracket supports and amber lamps
to outer light brackets using 1/4-20 x 1-1/4
hex head cap screws and hex lock nuts.
3-11.4 Connect warning light harnesses to
lights.
3-11.5 Attach SMV emblem and mounting
bracket to rear center frame bar using 1/2-13
x 5-1/2 hex head cap screws, 1/4-20 x 3/4
hex head cap screws, and hex lock nuts.
The SMV sign should be centered on the
rear bar of the frame.
3-21