St Stop Work In Progress - Newport LDS1000 User Manual

LDS1000
10.5.11
Related commands
ST
Use MNL
Syntax ST
Parameter
Description
Response
Error D
Example ST
The ST command stops the acquisitions in progress without deleting the
memory. The measurements performed up to receiving this command
are stored in the controller's memory.
The XN parameter keeps its value.
The command xxTT makes it possible to read the values stored if xx is
lower than XN.
TB
TE
TK
TM
TQ
TT
XN
Controller for Laser Diode Sensors
Stop Work in Progress
RMT ACT
None.
Stop work in progress (acquisition launched by TK, TM or TQ).
None.
Execution not allowed.
| Stop the work in progress and carry on.
Read error.
Read error code.
Acquisitions with trigger on TRIGG input.
Immediate acquisitions.
Acquisitions with synchronization on TRIGG input.
Proof read acquisitions.
Read number of measurements in memory.
47
NOTE
EDH0170FE1010 – 09/98