Table of Contents
Advertisement
Tractor Preparation/Attaching of
Pull Type Seeder
1. The Seeder is designed to be used with a CAT 2 or
CAT 3 Drawbar Hitch.
Do not allow any bystanders to stand between
the tractor and the implement while backing up to
the implement.
2. Align the tractor drawbar with the machine. Raise or
lower the hitch, as needed, using the jack. Attach the
unit with proper size hitch pin. See Table 3-1.
Table 3-1: Pin Size
DRAWBAR
CAT
Min Pin Size
2
1-1/4" (30mm)
3
1-1/2" (38mm)
3. Raise and rotate jack to stored position before setting
the machine in motion.
4. Clean all hydraulic couplings and attach to the
tractor.
5. If Transport Locks are not engaged, fully extend the
hydraulic lift cylinders and rotate Transport Locks in
the engaged position over the cylinder rods. Secure
with the Clevis Pins and Hairpin Cotters. See
Figure 3-5.
Figure 3-5: Transport Lock Engaged
F-1021-0719
DANGER
Max PTO HP
154 (115 Kw)
248 (185 Kw)
6. Attach safety chain to tractor allowing plenty of
movement for turning both directions. The safety
chain should latch securely to prevent it coming
loose. See Figures 3-6 and 3-7.
Figure 3-6: CAT 3 Ring Hitch
Figure 3-7: CAT 2 Clevis Hitch
7. Plug the 7 Pin Connector to tractor outlet, routing
cable by avoiding pinch points.
• Make sure the tractor has a good clean receptacle,
free of dirt and corrosion.
• Make sure the 7 Pin Connector is inserted ALL the
way in. With tighter fitting pins, operator may think
the Connector is all the way in, but really isn't.
• Make sure the tractor receptacle cover latches over
the keyway on the 7 Pin Connector to hold the
Connector in place.
• If an operator plugs in the 7 Pin Connector, but the
lights Do not seem to work right, check the above
items to make sure there is a good connection with
the 7 Pin Connector.
8. Install Clutch and any other Optional Harness to
tractor if applicable.
OPERATION
3-5
Advertisement
Table of Contents
