Table of Contents
Advertisement
OPERATION
Attaching to the Tractor, Pull Type
Version
1. Align the tractor drawbar with the machine. Raise or
lower the hitch, as needed, using the jack. Attach the
unit with proper size hitch pin and safety clip.
2. Always move the jack to the transport position before
setting the machine in motion.
3. Clean all hydraulic couplings and attach to the
tractor.
4. Fully extend the hydraulic lift wheel cylinders, and
place the cylinder lockouts in the transport lock
position over the cylinder rods. Secure the lockouts
with the lockout pins. See Figure 3-3.
5. Attach safety chain to tractor allowing plenty of
movement for turning both directions. The safety
chain should latch securely to prevent it coming
loose. See Figure 3-2.
Figure 3-2: Safety Chain
Seeder Transport Lock
(Pull Type Only)
To prepare the machine for transport, raise machine fully
and pin transport lock in place on each lift cylinder. See
Figure 3-3.
To prepare the seeder for field operation disengage each
transport lock and replace the pin. The lock rests on the
wheel arm; the pin is in front of lock. See Figure 3-4.
3-4
IMPORTANT
If the pin is not installed, the transport lock may
bounce up and cause significant damage to the
cylinder and fittings.
Figure 3-3: Transport
Figure 3-4: Field
1P480rev0718
Hide quick links:
Advertisement
Table of Contents
