Assembly - Landoll Brillion SS16 Operator's Manual

Sure stand ag seeder
Hide thumbs Also See for Brillion SS16:
Table of Contents

Advertisement

Do not work on or under this machine unless
securely blocked and supported by a hoist or
tractor or by other sufficient means.
Do not attempt to lift heavy parts manually. Use a
hoist or a fork lift to move these parts into
position.
NOTE
Refer to the repair parts manual F-1020 for identification
of parts and for the approximate relationship of the parts
in assembly.
To ensure alignment of assemblies, leave the nuts
loose until completion of final assembly. Use lock
washers or flat washers as specified. Spread all cotter
pins.
After completion of final assembly, tighten all nuts
evenly to prevent misalignment, distortion or binding.
Tighten all screws and nuts to the recommended
torques.
IMPORTANT
• If pre-assembled parts or fasteners are temporarily
removed, remember where they go. It is best to keep
parts separated.
• Check that all working parts move freely, bolts are
tight and cotter pins spread.
• Refer to the Torque Table for proper torque valves.
Note the different torque requirements for bolts with
lock nuts. See Page 4-1.
"Left" and "Right" refer to directions seen as if standing
behind the machine and facing in the direction of forward
travel.
F-1021-0719
CAUTION
WARNING
IMPORTANT
All harnesses must be firmly attached to machine
frame members, or nylon tubing, so they don't sag or
become torn loose by field debris. Use the tie straps
provided.
Check to be sure the harnesses at center of machine is
slack enough so as not to be stretched or interfered
with while rotating frame from transport to field
working position and vice versa.
Chapter 2

Assembly

2-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Brillion ssp16

Table of Contents