Table of Contents
Advertisement
ASSEMBLY
Drawbar Installation
Do not attempt to lift heavy parts manually. Use a
hoist or a fork lift to move these parts into
position.
1. Center the Drawbar Assembly on Seeder Frame and
attach using six 3/4-10 U-Bolts, Flat Washers and
Locknuts. Tighten. See Figure 2-1.
2-2
WARNING
Figure 2-1: Drawbar Installation
2. Install Toolbox to Drawbar cross member using two
3/8-16 x 1 Bolts, Flat Washers and Flanged
Locknuts.
3. Attach Air Manifold Assembly to the Drawbar cross
member using one 5/8-11 x 1-3/4 Bolt, Flat Washer
and Flanged Locknut.
4. Attach the Manual Holder to the Drawbar using two
1/4-20 x 1 Bolts, Flat Washers and Locknuts.
5. Install Hose Support to the Drawbar using one
5/8-11 x 2 Bolt, Flat Washer and Flanged Locknut.
6. Place Wrenches and Calibration Crank in Toolbox.
F-1021-0719
Advertisement
Table of Contents
