Table of Contents
Advertisement
ASSEMBLY
Hydraulic Lift Circuit
1. Install the SMV Bracket to the Frame Bracket with
5/16-18 x 1 Bolts, Flat Washers and Locknuts. See
Figure 2-7.
2. Install Bulkhead Tees into SMV Bracket using
supplied hardware.
3. Install Elbow Restrictor into base end of each 3 x 8
Hydraulic Cylinder. See Figure 2-8.
4. Install Elbow Fitting into rod end of each 3 x 8
Hydraulic Cylinder.
2-8
5. Attach a 3/8 x 53 Hose to each Cylinder Base End
Elbow Restrictor and a 3/8 x 64 Hose to each
Cylinder Rod End Elbow.
6. Route the hoses along frame to Bulkhead Bracket
and attach to Bulkhead Tees.
7. Connect 3/8 x 214 Hoses to Bulkhead Tees, route
the hoses up the Drawbar.
8. Install 08MJ x 08MOR Adapter and Male Coupler
into each hose end.
Figure 2-7: Hydraulic Layout
F-1021-0719
Advertisement
Table of Contents
