Table of Contents
Advertisement
MAINTENANCE
Roller Axle Assembly
After an initial run of 5-10 hours, check the Roller Axle
Assemblies to ensure that the wheels are tight to one
another. If not slide the Rear Roller Wheels tight together
and adjust the Axle Clamps.
Front Roller push wheels against welded Roller End
Plate and adjust the Axle Clamp. See Figure 4-4.
Figure 4-4: Front Roller Axle Assembly
Figure 4-5: Clamp Tightening
Clamp Tightening
Tighten the Clamp Socket Head Bolt. Torque to 75ft/lbs.
Thereafter check assemblies every 50-100 hours. See
Figure 4-5. Clamps must be assembled with the open
section straddling the welded seam of the drum pipe.
NOTE
Failure to locate the clamp band bolt over the weld will
cause clamp band to loosen and slide.
F-1021-0719
4-5
Advertisement
Table of Contents
