Table of Contents
Advertisement
ASSEMBLY
Drawbar Model LED Warning Lamps
Installation
1. Amber Lamps are assembled to frame
ends/extremity of machine. Unscrew Amber Lamp
Jam Nut if not already removed from Lamp Stud so
that the Nut and Washers fall down to the plug. Place
a Amber Lamp inside a Lamp Shield so that the
Lamps threaded stud sits in the radius of the slot and
insert the stud into each end Frame Bracket key slot
large diameter. Secure Amber Lamps with Jam Nut
and Washers. See Figure 2-9.
2. Secure Lamp Shields onto end Frame Brackets with
1/4-20 x 1 Bolts and Locknuts.
3. Attach Lamp Shields to the Wheel Arm Shields with
1/4-20 x 1 Bolts and Locknuts.
4. Red Lamps are assembled to the Wheel Arm
Shields. Install the Red Lamps inside the Lamp
Shields by sliding the lamp stud into the slot. Secure
Red Lamps with Jam Nut and Washers.
5. Attach the Flasher Control Module onto the inner
Drawbar Bracket using two 1/4-20 X 1-1/2 Bolts, Flat
Washers and Locknuts.
IMPORTANT
Cables are marked Left or Yellow / Right or Green.
6. Lay out the LED Lamp Harness and attach the
harness to the Flasher Control Module.
7. Route the left and right 3 plug cable along the frame
and connect to each Red LED Lamp.
8. Route the remaining left and right 2 plug cables
along the left and right of the frame and under the
Seedbox Supports, connect into each Amber LED
Lamp.
9. Layout the 7 Pin Harness and attach the harness to
the Light Module.
10. Attach SMV Sign using two 5/16-18 x 1 Bolts, Flat
Washers and Locknuts.
11. Route the 7 Pin Harness through the Hose Support
and up the Drawbar.
12. Bundle and secure with tie straps after Nylon Tubing,
all Harnesses and Hydraulic Hoses have been
installed.
2-10
IMPORTANT
All harnesses must be firmly attached to machine
frame members, or nylon tubing, so they don't sag or
become torn loose by field debris. Use the tie straps
provided.
Check to be sure the harnesses at center of machine
is slack enough so as not to be stretched or
interfered with while rotating frame from transport to
field working position and vice versa.
NOTE
The 7 Pin harness connects to the tractor socket when in
use. When not in use, it can be stored in the Plug Holder
Cut Outs on the left front side of the Drawbar. Allow
enough harness length to reach tractor socket and roll or
fold up excess and secure hydraulic hose.
F-1021-0719
Advertisement
Table of Contents
