Table of Contents
Advertisement
ASSEMBLY
Clutch and Seed Shaft Sensor
Electrical Layout - Optional
The clutch is controlled by a toggle switch on the
Console.
1. Route Clutch Harness along front frame tube of
seeder and under SMV Bracket, with 2 Spade
Connector to the Left /Clutch Transmission and the 3
Pin Connector to the Right/Seed Shaft Sensor.
Route Clutch Harness Center Plug (6 pin) through
SMV Bracket bottom opening and insert plug into the
front facing cut out. Secure with two M5-.08 x 14
BHCS Screws. See Figure 2-17.
2-18
Figure 2-15: Clutch and Seed Shaft Sensor Schematic
2. Connect either 4 ft (3Pt) or 20 ft (Drawbar) Extension
Harness to the Clutch Harness. Route along 3Pt
Hitch or Drawbar towards front of machine. See
Figure 2-15.
3. Plug 2 Spade connector to the Clutch Shaft
Assembly Cable.
4. Plug 3 Pin Connector into the Seed Shaft Sensor.
5. Secure Harnesses with tie straps after Nylon Tubing,
Harnesses and Hydraulic Hoses if (applicable) have
been installed.
F-1021-0719
Advertisement
Table of Contents
