Table of Contents
Advertisement
OPERATION
1. If you know the number, select it using the UP and
DOWN buttons. When you press the
button, the Acre Counter will accept the number in
the display as the new pulses per 400 feet. See
Table 3-2.
2. If you Do not know the pulses per 400 feet, press and
hold the UP and DOWN buttons until the "0" appears
in the display. The "PULSES" LED will blink. The
acre counter is now counting shaft rotations. Enter
the cab and drive 400 feet. Press the
to wake up the acre counter. The "PULSES" LED will
light. The number displayed is the pulses per 400
*
feet. Press the
/FUNC button to accept the setting.
If a password is set, you will not be able to adjust the
pulses.
Width
*
Press the
/FUNC button until the "WIDTH" LED is lit.
The number displayed is the length of your implement in
feet.
To adjust the width, press the UP and DOWN buttons. If
a password has been entered, you will not be able to
adjust the width.
The width can be adjusted from .1 to 99.9 feet, in tenths
of a foot.
Password
The password function allows you to protect the total
acre count, pulses per 400 feet, and width settings with a
password. This stops anyone from accidentally changing
those settings. When the acre counter is shipped, the
password is disabled. You can modify the pulses per 400
feet and implement width at any time.
*
Press the
/FUNC button until the "PASS" LED is lit. The
digits will display the word "Ent" or "dIS".
If the display shows "dIS". The password is disabled.
The total acre count, pulses/400 feet, width, and
password settings can be adjusted using the UP and
DOWN buttons. The password can also be changed
using the UP and DOWN buttons.
If the display shows "Ent": You must enter your password
using the UP and DOWN buttons. When your password
*
is displayed, press the
password. If the password is correct, you will be able to
change the acre counter settings. The password will be
viewable until the acre counter powers down. When the
acre counter is powered up again, you will have to
re-enter the password to change settings.
If the password is correct, you will be able to change the
acre counter settings. The password will be viewable
until the acre counter powers down. When the acre
counter is powered up again, you will have to re-enter the
password to change settings.
3-12
*
/FUNC
*
/FUNC button
/FUNC button to test the
If the password is not correct, you will not be able to
change the acre counter settings. When the "PASS"
function is selected again, "Ent" will appear in the
display.
Changing the Password
Select a new password using the UP and DOWN
*
buttons. Press the
/FUNC button until the word "SEt"
appears in the display. Release the
number in the display is your new pass code. Make sure
you record this number. Press and hold the
button until the word "dIS" appears in the display.
If the password is forgotten, it can be disabled by
removing the batteries. The password is intended for
rental units. It is recommended that a seal be affixed to
the rear plate of the acre counter to determine if the
settings have been tampered with.
Battery Replacement
The battery operated acre counter uses 3 AA batteries.
The batteries should last between 5 and 10 years. The
acre counter will last much longer than that. Eventually,
you will have to replace the batteries. The "BATT" LED
will light when the batteries require replacement. Remove
the acre counter from the implement and undo the 4
screws on the back of the case. This will separate the
housing from the rear plate. Replace the batteries with 3
high quality AA alkaline batteries.
See "Acre Meter Troubleshooting" on page 4-8.
*
/FUNC button. The
*
/FUNC
F-1021-0719
Advertisement
Table of Contents
