Table of Contents
Advertisement
ASSEMBLY
Clutch and Seed Shaft Sensor
Console w/Scale Indicator Tractor
Installation - Optional
1. Mount Clutch and Seed Shaft Sensor Console w/
Scale Indicator Angle Bracket onto Tractor Bracketry
where convenient for the operator.See Figure 2-20.
2. Attach Straight Bracket to Angle Bracket using
1/2-13 x 1 Bolt and Flanged Ny-Lok Nut.
3. Attach the Scale Display Bracket to Straight Bracket
using 3/8-16 x 1-1/4 Bolts and Flanged Ny-Lok Nuts.
4. Attach the Console to Scale Display Bracket using
two 1/4-20 x 3/4 Bolts, Flat Washers and Locknuts.
5. Attach the GT400 Indicator Bracket to Scale Display
Bracket using 1/4-20 x 1/2 Bolts and Spiral Flanged
Locknuts.
Figure 2-20: Seed Shaft Sensor and Clutch Console w/Scale Indicator
2-22
6. Tilt the GT400 Scale Indicator to latch the top of the
GT400 Indicator Bracket. Secure bottom with 1/4-20
x 1/2 Bolts and Spiral Flanged Locknuts.
7. Plug the Power and Indicator Cables into the bottom
of GT400 Scale Indicator.
8. Attach 3 Port Splitter to Indicator Cable.
9. Plug Clutch and Seed Shaft Sensor Console 3 Pin
Power Cable into the tractor and 9 Pin Cable into the
4ft or 20ft Extension Harness.
10. Plug GT400 Scale Indicator Power Cable into the
Tractor and connect each Load Cell Cable to 3 Port
Splitter.
11. Secure cables with tie straps.
12. Refer to GT400 Vendor Operator's manual for
cabling and set-up instructions.
F-1021-0719
Advertisement
Table of Contents
