Table of Contents
Advertisement
Clutch Installation - Optional
If not equipped contact dealer to order.
1. Install Flangettes and Bearings onto Clutch
Transmission with 5/16-18 x 3/4 Carriage Bolts, Lock
Washers and Nuts. Do not tighten at this time.
2. Install a Coupler onto Speed Reducer Shaft and the
Clutch Shaft, while maintaining 9/32" gap between
the Coupler Sprockets. Ensure Square Keys are in
place.
3. Lift Clutch Shaft Assembly into compartment and
through the Bearing. Align and connect Couplers
with Double Chain. Tighten Bearing Hardware and
Lock Collar.
F-1021-0719
Figure 2-14: Clutch Installation - Optional
4. Secure Clutch Torque Arm to the Clutch
Transmission Tab with 1/4-20 x 1 Bolt, Spacer, Flat
Washer, and Locknut. Clutch Arm must be free to
float 1/16 of an inch.
5. Replace current transmission shaft with Clutch
Transmission Shaft. Insert Clutch Transmission
Shaft through Sprockets and through the Bearings.
6. Install Chain on the Clutch Sprocket and the 30T
Sprocket. Tighten Bearing Hardware and Lock
Collar.
7. Install Grommet.
8. Route Clutch Cable through Hose Clamp. Install
Hose Clamp to Clutch Transmission.
ASSEMBLY
2-17
Advertisement
Table of Contents
