Table of Contents
Advertisement
OPERATION
Attaching/Detaching 3Pt Hitch Seeder
To prevent the implement from tipping forward
on the frame, disengage parking stand only when
the seeder is fully attached to the tractor. Be sure
to observe the following sequences.
Hooking Up the Seeder:
1. Attach seeder to the tractor. Raise the Seeder.
2. Remove the 3/4" Pin and lift the Parking Stands until
the bottom hole is aligned with the bracket hole.
Replace the 3/4" Pin. Both sides. See Figures 3-2.
3. Remove the 3/4" Parking Pins from the Frame Arm
Guides and place into frame tabs. Both sides. See
Figures 3-3 and 3-4.
Unhooking the Seeder:
1. Raise Seeder, remove the 3/4" Pins and lower the
Parking Stands, align one of the three holes with the
bracket hole depending upon the site ground,
replace the 3/4" Pins. Both sides. See Figures 3-2.
2. Insert the 3/4" Parking Pins into the Frame Arm
Guide to lock the Rear Roller Arms. Both sides. See
Figure 3-4.
3. Lower Seeder and disconnect the tractor from
Seeder.
Figure 3-2: Parking Stand (Shown with parts
removed for clarity)
3-4
WARNING
Figure 3-3: Parking Pin Stored
Figure 3-4: Parking Pin Engaged
F-1021-0719
Advertisement
Table of Contents
