Table of Contents
Advertisement
Clutch and Seed Shaft Sensor
Console Tractor Installation -
Optional
1. Mount Clutch and Seed Shaft Sensor Console Angle
Bracket onto Tractor Bracketry where convenient for
the operator. See Figure 2-16.
2. Attach Straight Bracket to Angle Bracket using
1/2-13 x 1-1/2 Bolt and Flanged Ny-Lok Nut.
3. Attach the Clutch and Seed Shaft Sensor Console to
the Straight Bracket using two 1/4-20 x 1 Bolt, Flat
Washers and Locknut.
F-1021-0719
Figure 2-16: Clutch and Seed Shaft Sensor Console - Optional
4. Plug Clutch and Seed Shaft Sensor Console 3 Pin
Power Cable into the Tractor Convenience Outlet
and 9 Pin Cable into the 4ft or 20ft Extension
Harness.
5. Check clutch operation: Clutch will engage when
power is applied. (Clutch will make a clicking sound).
Set seeder on the ground and drive a short distance
while turning switch on and off. The seed shaft will
stop rotating when switch is turned to "NO SEED"
position. (See "Seed Rate Adjustment" on
page 3-8.)
ASSEMBLY
2-19
Advertisement
Table of Contents
