Table of Contents
Advertisement
ASSEMBLY
Do not work on or under this machine unless
securely blocked and supported by a hoist or
tractor or by other sufficient means.
S-Tine Harrow Installation - Optional
1. Attach the two Harrow Mounting Brackets to the
Frame Tube with 3/4-10 U-Bolts, Flat Washers, and
Locknuts.
2. Slide the Harrow Adjuster up into the Harrow
Mounting Bracket. Align the holes and insert Hitch
Pin and secure with Hair Pin Cotter.
3. Insert the S-Tine Assembly into the Harrow Adjuster
Cutout. Ensure it's equally spaced from side to side.
Secure with 5/8-11 U-Bolts, Thick Washers, and
Locknuts.
4. Attach the Sidewind Jack to the Harrow Mounting
Brackets using four 5/8-11 x 1-3/4 Bolts and
Locknuts.
5. Attach the bottom of each Jack to the bottom of the
Harrow Adjuster. Cranking the Jack up or down to
align the holes. Secure with a 1/2-13 x 3-3/4 Bolt and
Flanged Locknut.
6. Locate and install S-tines as needed to cover tractor
tire tracks. Suggested pattern is to use 1-3/8" point
on center tine and 2-1/2" points on each side of
wheel track. If needed, additional tines may be
purchased and installed.
2-26
CAUTION
F-1021-0719
Advertisement
Table of Contents
