Pull Type Seeder Assembly; Drawbar Assembly - Landoll BRILLION SL Series Operator's Manual

Pull Type Seeder Assembly

Drawbar Assembly

When shipped, seeder comes assembled except for
lights, wheels, and drawbar.
NOTE
Your exact seeder model may vary slightly from the
illustration. Additional parts identification and location can
be obtained from reviewing parts catalog 1P341.
IMPORTANT
If a pre-assembled component or fastener is temporarily
removed, ensure it is correctly re-installed per these
instructions.
• Check that all working parts move freely, bolts are
tight and cotter pins are spread.
Figure 2-3: Pull Seeder Drawbar Installation
ASSEMBLY INSTRUCTIONS
• Park the seeder in a work area that has a level
surface and make sure it is blocked securely so that it
cannot roll.
NOTE
"Left" and "Right" refer to directions seen as if standing
behind the machine and facing in the direction of forward
travel.
1. Loosen the two rolled up hydraulic hoses from the
front frame shipping position. Ensure the hoses are
not interfering with where the drawbar is to be
attached.
2. Position the drawbar on center of frame and secure
with four 5/8-11 x 6-11/16" x 5-1/2" U-bolts,
Lockwashers, and Nuts from bag in seedbox. See
Figure 2-3.
3. Attach the Hose Support to the Drawbar with 5/8-11
x 1-1/2 Screws, Lockwashers and Nuts.
2-3