Table of Contents
Advertisement
General Operation
1. The minimum horsepower requirements are typically
6-8 horsepower per foot. This will vary widely due to
speed, depth, moisture, and types of soils. Local
dealers can help in making recommendations for
your areas. For 3Pt Hitch models size tractor by 3Pt
Hitch Capacity.
2. Operating speed is typically 4.5-6 mph. Excessive
speed can result in undesirable germination, seeder
bouncing, or other unpredictable results. Reduce
speed in rocky conditions to prevent wheel breakage.
Transporting the Seeder
1. Check and follow all federal, state, and local
requirements before transporting the Seeder.
2. The Seeder should be transported only by tractor
required for field operation. The implement weight
should not exceed more than 1.5 times the tractor
weight. Maximum transport speed for the Seeder is
20 mph for the implement.
Excessive speed may result in loss of control of
the tractor and implement, reduced braking
ability, or failure of the implement tire or
structure. Do not exceed the implement
maximum specified ground speed regardless of
the capability of the maximum tractor speed.
3. When towing equipment in combination, the
maximum equipment ground speed shall be limited
to the lowest specified ground speed of any of the
towed implements.
4. Maximum transport speed shall be the lesser of
travel speed specified in the operator's manual,
speed identification symbol, information sign of
towed equipment, or limit of road conditions.
5. Slow down when driving on rough roads. Reduce
speed when turning, or on curves and slopes to
avoid tipping. Equipment altered other than the place
of manufacture may reduce the maximum transport
speed. Additional weight, added tanks, harrowing
attachments, etc. may reduce implement load
carrying capabilities.
6. Before transporting:
a. Know the height and width of the implement
being towed. Markers, tanks, attachments, etc.
can increase the height and width of the
implement.
F-1021-0719
CAUTION
DANGER
Stay away from power lines when transporting,
extending implement. Electrocution can occur
without direct contact.
b. Check to see that the tractor hitch capacity is
rated to carry the weight of the Seeder Hitch.
c. Use provided pins that properly fits the Lift Arms
or Quick Hitch and Implement Hitch.
d. Plug in the safety lights to the tractor 7 Pin
Connector.
e. Fully raise the Seeder Hydraulic Lift and 3Pt
Hitch.
f.
Make sure all Transport Locks and Hair Pin
Cotters and Clevis Pins are installed. See
"Transport Lock Engaged" on page 3-5.
WARNING
Failure to use transport lock pins during
transport may result in permanent equipment
damage, serious injury, or death.
g. Check all tires for proper inflation, and that lug
nuts are properly torque. (See "Tires" on
page 4-3.)
h. Verify that all warnings lights, SMV sign,
reflectors, and safety decals are clearly visible
and functioning properly.
i.
Transport during daylight hours whenever
possible. Always use flashing warning lights,
except where such use is prohibited by law.
Make sure lights, reflectors and SMV emblem
are clearly visible and operating. Remove any
obstructions such as dirt, mud, stalks or residue
that restricts view before transporting. See
Figure 3-19.
Figure 3-19: SMV Sign
OPERATION
3-15
Advertisement
Table of Contents
