Table of Contents
Advertisement
OPERATION
Coil Tine Harrow - Optional
The Seeder has a Optional Coil Tine Harrow to remove
tire tracks before the rollers compact the soil.The coils
are individually mounted for flexibility and backup
protection. The Tines depth should be adjusted so the
tips are approximately 2" into the soil.
NOTE
The tines will hang straight down when the implement is
raised.
1. The Coil Tine may be adjusted up or down as
needed.
2. Adjust the Coil Tine Harrow depth by removing the
3/4 x 4-1/2 Hitch Pin. Crank the Sidewind Jack up or
down to achieve the desired depth. Re-Insert Hitch
pin and secure with Hair Pin Cotter. Both sides
should be set at the same depth. See Figure 3-17.
Figure 3-17: Coil Tine Harrow Adjustment
S-Tine Harrow - Optional
The Seeder has an Optional S-Tine Harrow to remove
the tire tracks before the rollers compact the soil.
NOTE
S-tines should not be operated any deeper than
necessary to remove tractor tire tracks. Otherwise, wet
soil is brought up which will stick to the rollers, draft load
is increased, and under some conditions, tines may
deflect back to rollers and break.
3-14
1. The S-Tine Harrow depth may be adjusted for a
deeper more aggressive depth or shallower for
minimal disturbance.
2. Adjust the S-Tine Harrow depth by removing the 3/4
x 4-1/2 Hitch Pin. Crank the Sidewind Jack up or
down to achieve the desired depth. Re-Insert Hitch
pin and secure with Hair Pin Cotter. Both sides
should be set at the same depth. See Figure 3-18.
Figure 3-18: S-Tine Harrow Adjustment
Seed Shaft Console LED with
Clutch Control - Optional
Basic Operation:
During normal operation the Console LED for the Seed
Shaft will not be illuminated. The Shaft Sensor will be
activated by the Spacer with Magnet installed on the
Seed Shaft being monitored. The Shaft Sensor is a
standard Loup Shaft Sensor, set to 20 second delay
timing. When no signal is detected for 20 seconds by the
sensor, the LED in the Console will illuminate and the
audible alarm will sound indicating a fault. The alarm will
become silent after 30 seconds and will not sound again
until the Seed Shaft returns to a fully functional condition.
NOTE
If Shaft Sensor stall alarm occurs, be aware that the
seeder has not been planting for 20 seconds.
The Clutch Master toggle switch allows you to go from
"SEED" to "NO SEED" operations.
F-1021-0719
Advertisement
Table of Contents
