Table of Contents
Advertisement
ASSEMBLY
3Pt Hitch Model LED Warning Lamps
n
Installatio
1. Unscrew Amber Lamp Jam Nut if not already
removed from Lamp Stud so that the Nut and
Washers fall down to the plug. Place a Amber Lamp
inside a Lamp Shield so that the Lamps threaded
stud sits in the radius of the slot and insert the stud
into each end Frame Bracket key slot large diameter.
Secure Amber Lamps with Jam Nut and Washers.
See Figure 2-10.
2. Secure Lamp Shields onto end Frame Brackets with
1/4-20 x 1 Bolts and Locknuts.
3. Install the Red Lamps to the inner Light Mount
Brackets by sliding the lamp cable into the slot.
Secure Red Lamps with Jam Nut and Washers.
4. Install the SMV Bracket to the bracket weldment
using four 5/16-18 x 1 Bolts, Flat Washers and
Locknuts. Attach SMV Sign using two 5/16-18 Bolts,
Flat Washers and Locknuts.
5. Attach the Flasher Control Module to the underside
of the Manual Holder using two 1/4-20 x 1-1/2 Bolts,
Flat Washers and Locknuts.
IMPORTANT
Cables are marked Left or Yellow / Right or Green.
6. Lay out the LED Lamp Harness and attach the
harness to the Flasher Control Module.
7. Route the left and right 3 plug cable along the frame
and connect to each Red LED Lamp.
8. Route the remaining left and right 2 plug cables
along the left and right of the frame and under the
Seedbox Supports, connect into each Amber LED
Lamp.
9. Layout the 7 Pin Harness and attach the harness to
the Light Module.
10. Route the 7 Pin Harness up the 3Pt Hitch.
11. Bundle and secure with tie straps after Nylon Tubing,
and all Harnesses have been installed.
2-12
IMPORTANT
All harnesses must be firmly attached to machine
frame members, or nylon tubing, so they don't sag or
become torn loose by field debris. Use the tie straps
provided.
Check to be sure the harnesses at center of machine
is slack enough so as not to be stretched or
interfered with while rotating frame from transport to
field working position and vice versa.
NOTE
The 7 Pin harness connects to the tractor socket when in
use. When not in use, it can be stored in the Plug Holder
on the 3Pt Hitch. Allow enough harness length to reach
tractor socket and roll or fold up excess and secure
hydraulic hose or 3Pt Hitch.
F-1021-0719
Advertisement
Table of Contents
