Seed Shaft Sensor Kit - Small Seedbox - Landoll SSB-8 Operator's Manual

Seed Shaft Sensor Kit - Small
Seedbox
Remove the four 10-24 x 3/4" Self Tapping Screws from
the Magnet Wheel Assembly. Position the rounded half of
the Magnet Wheel Assembly on the seed shaft. Ensure it
fits squarely onto shaft. Mount magnet half to the
rounded half. Ensure it fits squarely onto shaft. Fasten
the two halves together using four #10-24 x 3/4" Self
Tapping Screws. Do not over tighten.
Seed Shaft
Machine Screw
Sensor Bracket
8-1/2" Spacing
Magnet Wheel
Assembly
3/8 Sq Shaft
,
1/4-20 x 3/4
Existing
Lock Washer, 1/4
Existing
Nut, 1/4-20
Screw,Self Tapping
#10-24 x 3/4
Seed Shaft
Sensor
Retaining Nut
Figure 2-20: Small Box Senor Brackets
Identify the seed cups on either side of the Magnet
Wheel Assembly and remove the 1/4-20 hardware. Insert
Sensor into Shaft Sensor Bracket slot. Note: 8 and 10
foot seeders use Sensor Bracket with 8-1/2" spacing.
Insert a 1/4-20 x 3/4" Machine Screw into each seed cup.
Align the Shaft Sensor Bracket with the two 1/4-20 x 3/4"
Screws. Secure with existing Lock Washers and Nuts.
Slide/Position Seed Shaft Sensor so it is 1/8" from the
magnet. See Figure 2-24. Tighten both Retaining Nuts.
Screw, Self Tapping
#10-24 x 3/4
Shaft Sensor
Bracket
Shaft Sensor
Bracket
Nut, 1/4-20
ASSEMBLY INSTRUCTIONS
Seed Shaft
Sensor
Retaining Nut
Sensor Bracket
8-1/2" Spacing
Magnet Wheel
Assembly
3/8 Sq Shaft
Seed Shaft
Machine Screw,
1/4-20 x 3/4
Existing
Lock Washer, 1/4
Existing
2-19