Seed Shaft Sensor Kit (Optional) - Landoll BRILLION SL Series Operator's Manual

ASSEMBLY INSTRUCTIONS

Seed Shaft Sensor Kit (Optional)

Remove the two #10 x 24 x 3/4" self tapping screws from
the Magnet Wheel Assembly. Position the rounded half of
the Magnet Wheel Assembly on the seed shaft. Ensure it
fits squarely onto shaft. Mount magnet half to the
rounded half. ensure it fits squarely onto shaft. Fasten the
two halves together using two #10-24 x 3/4" self tapping
screws. Do not over tighten.
2-12
Identify the seed cups on either side of the Magnet
Wheel Assembly and remove the 1/4-20 hardware. Insert
Sensor into Shaft Sensor Bracket slot.
Insert a 1/4-20 x 3/4" machine screw into each seed cup.
Align the Shaft Sensor Bracket with the two 1/4-20 x 3/4"
screws. Secure with existing lockwashers and nuts.
Slide/Position Seed Shaft Sensor so it is 1/8" from the
magnet. See Figure 2-13. Tighten both retaining nuts.
Figure 2-12: Seed Box Brackets
1P342